Car window replacement can be done by the novice if she or he takes their time and has some instruction. It doesn’t require any special knowledge or expensive tools to car glass, but it does take patience! Here we will talk about replacing a fixed car شیشه تویوتا کمری glass that is bonded to the car body instead of being set into a extrenal frame.
If you are going to replace car glass that is not emerge a frame, then you will basically have to “cut” the old glass out of the car. This action requires a few inexpensive tools that are often not in a common tool collection. You might need a joint of piano line to use as a saw, and a couple of inexpensive suction cup handles to lift out the old glass (if it is still in one piece) and to place the new glass into position without pressing the edges of the glass.
The first step is to remove any molding that encircles the window. Molding can be attached in several other ways. It may be attached with some sort of movies, glued on, or may be just pushed onto a lips on the car body. This is one place where manufacturing facility service information comes in handy! Some glass is flush-mounted with the exterior surface of the body and does not have any molding to remove. You also may need to remove several trim panels inside the car. Before starting to cut out the broken car window, apply recorded argument to the car body entirely around the window to protect the paint. Next, use an awl to make a hole through the adhesive between the glass and the body. Then push a piece of piano line through the hole, grab a associate to work the other end of the line, and use a sawing motion to cut the adhesive entirely around the window. Once you have completely sawn entirely around the broken car window, use the suction cup handles to pull the glass out of the car body.
That was the straightforward part! The next step is to remove all the old adhesive from the car body, which isn’t difficult but it can be tedious! Some service manuals instruct you to leave a thin layer of the original adhesive on the car and just smooth it out, but if it is an older vehicle that may not be your best option. Once you have removed all the old adhesive (or smoothed it out), you will need to clean the surfaces thoroughly using do away with alcohol or the cleaner specified by the instructions that was included with the new adhesive. Then you will need to prepare both the new glass surface and the surface that the new adhesive contacts. Again, follow the instructions for the type of new adhesive you are using. There may be a primer that needs to be applied to the old adhesive, and sometimes a different primer that goes on the glass. Pay attention to any curing times that are specified. Be careful not to touch any of the contact surfaces with your hands, or you could prevent the adhesive from securing and bonding properly. After prepping both surfaces, apply a bead of adhesive around the edge of the glass as recommended by the service manual and/or the adhesive instructions. You may be recommended to make the bead slightly larger in the corner areas.
After the new adhesive has been applied and any recommended curing times have been observed, use the suction cup handles to install the new glass into position. Consistently press the glass into the adhesive until it is fully seated entirely around. Do not disturb the car for several hours according to the adhesive instructions, and then be careful not to slam the doors and or drive on any excessively rough roads for several days so that the adhesive has had time to fully bond with both surfaces.
That covers the reccommended procedure for auto glass installation. Car window replacement could possibly be done by a driver that doesn’t have any experience or training in this area, but some jobs are definitely easier than others! If this action doesn’t sound like something you want to tackle yourself, there certainly isn’t a shame in taking your car to an auto glass purchase a replacement, and most shops will come to your home or workplace to do it for you.